Difference between revisions of "DFF4.1 Building Instructions"

From KONNEKTING Wiki
Jump to navigation Jump to search
Line 26: Line 26:
 
|8
 
|8
 
|3mm LED, green
 
|3mm LED, green
 +
|-
 +
|8
 +
|3mm LED spacer, 5mm height
 
|-
 
|-
 
|1
 
|1

Revision as of 09:17, 6 April 2018


Preparation

Check that all parts are there:

Pcs. Part
2 M3 hex-spacer, nylon, 15mm
2 M3 hex-spacer, nylon, 18mm
4 M3 screw, nylon
8 relay
8 screw terminals, cage
8 3mm LED, green
8 3mm LED spacer, 5mm height
1 3mm LED, red
8 tactile push button, xx mm
1 tactile push button, xx mm
1 DIN Rail enclosure, consisting of:
  • black bottom
  • white case
  • white front panel
  • 5 pcs terminal guards for screw terminals
  • 1 pcs KNX cover
  • 1 pcs terminal guard for heat-flow
  • 1 pcs terminal guard, closed
1 MiniUSB socket, vertical
2 micromatch socket, 2x3 pin
1 micromatch socket, 2x8 pin
1 micromatch socket, 2x4 pin
2 micromatch plug, 2x3 pin
1 micromatch plug, 2x8 pin
1 micromatch plug, 2x4 pin
1 pcs of flat cable
1 PCB enclosure cover, printed and drilled
1 M0dularis+ controller PCB
1 Frontend PCB, 8 Buttons, 8 LEDs
1 Application PCB, 8x BiRelay
1 MicroBCU with pinheaders

Take the flat cable and cut the following lengths and ensure, each cut part has it's own "red wire":

  • xx cm, 6 wires
  • xx cm, 8 wires

The result shoud look like this:

INSERT IMAGE HERE

Carefully put the micromatch plugs (2x3 for 6-wire and 2x4 + 2x8 for the 8-wire) onto the cut flat cable as shown here:

INSERT IMAGE HERE

Carefully use a pliers to crimp the plug. Be really careful and take you time. Otherwise you risk damage of micromatch plug!

INSERT IMAGE HERE (pliers + micromatch)

The result should look like this:

INSERT IMAGE HERE

Controller

Frontend

Application

Mechanical