Difference between revisions of "Modular LED Dimmer 1-12CH"
| (One intermediate revision by the same user not shown) | |||
| Line 8: | Line 8: | ||
|- | |- | ||
! Phase | ! Phase | ||
| − | | | + | | Beta Version in productive environment |
|- | |- | ||
! µC-Board | ! µC-Board | ||
| − | | Arduino Pro Mini/Pro Micro/Micro/Mega 2560 | + | | Arduino Pro Mini/Pro Micro/Micro/Mega 2560/ItsyBitsyM0 |
|- | |- | ||
! µC | ! µC | ||
| − | | atmega328p/atmega32u4/atmega 2560 | + | | atmega328p/atmega32u4/atmega 2560/SAMD21 |
|- | |- | ||
! KNX | ! KNX | ||
| − | | | + | | [[SiemensBCU]] / [[MiniBCU]] / [[MicroBCU]] |
|} | |} | ||
| Line 33: | Line 33: | ||
Maybe for some configurations I (or someone else) will design a pcb. | Maybe for some configurations I (or someone else) will design a pcb. | ||
| + | |||
| + | |||
| + | While the current prototype runs on a Mega2560 Board, I plan switiching to SAMD21 on a ItsyBitsyM0 Board with MicroBCU and a PCA9685 I2C PWM Driver. | ||
| + | With this setup 24 channels in a 9TE casing seem to be possible. | ||
Latest revision as of 08:05, 27 August 2019
| Modular LED Dimmer 1-12CH | |
|---|---|
| Developer | SirSydom |
| Phase | Beta Version in productive environment |
| µC-Board | Arduino Pro Mini/Pro Micro/Micro/Mega 2560/ItsyBitsyM0 |
| µC | atmega328p/atmega32u4/atmega 2560/SAMD21 |
| KNX | SiemensBCU / MiniBCU / MicroBCU |
Short Description
The idea behind this "device" is to create a common software and hardware design, to enable the advanced user to build a custom LED-Dimmer.
Soldering and PCB will be limited to Breadboard, so everyone who knows which side of the soldering iron will get hot can build it.
It will support a range of 1 up to 12 channels using the 16bit timer/pwm of the atmega µControllers.
Depending on the number of channels, it can be built into a REG-Case for central usage or into module case for decentral usage.
It will support CV (constant voltage) LED up to 24V and CC (constant current) LED.
Maybe for some configurations I (or someone else) will design a pcb.
While the current prototype runs on a Mega2560 Board, I plan switiching to SAMD21 on a ItsyBitsyM0 Board with MicroBCU and a PCA9685 I2C PWM Driver.
With this setup 24 channels in a 9TE casing seem to be possible.