Difference between revisions of "Recommended Arduino Boards"
Konnekting (talk | contribs) |
Konnekting (talk | contribs) |
||
| Line 27: | Line 27: | ||
Our current and clear recommendation is, to use a SAM21G18 based board, as the chip provides 32k RAM and 256k Memory and 48Mhz clock speed. So plenty of space and performance at lowest possible current consumption. | Our current and clear recommendation is, to use a SAM21G18 based board, as the chip provides 32k RAM and 256k Memory and 48Mhz clock speed. So plenty of space and performance at lowest possible current consumption. | ||
| + | |||
| + | = Boards we can recommend = | ||
| + | |||
| + | == Elecrow Crowduino M0 SD == | ||
| + | |||
| + | '''Attention:''' this boards runs a "M0 bootloader" and not the "Zero Bootloader". So you have to change the bootloader first | ||
| + | |||
| + | [[Image:https://www.elecrow.com/media/catalog/product/cache/1/small_image/150x150/9df78eab33525d08d6e5fb8d27136e95/1/4/14649511760.jpg]] | ||
| + | |||
| + | https://www.elecrow.com/crowduino-m0-sd-p-1649.html | ||
Revision as of 10:40, 13 December 2018
Clarification
There are two major Arduino "sources" available:
- www.arduino.cc
- www.arduino.org
The difference between both is:
- They use different bootloaders
- They use different platform-implementations
We focus on devices found on www.arduino.cc and support following chips for following devices:
- Atmel ATmega 328P
- Arduino Nano
- Arduino ProMini
- Atmel ATmega 32U4
- Arduino Leonardo
- Arduino Micro
- Atmel/Microchip SAMD21G18
- Arduino Zero
If you buy cheap Arduino boards from ebay or aliexpress, you should check that you're running the correct bootloader. Otherwise you may run into conflicts with the arduino platform for the boards, because our KONNEKTING Device Library has been developed and tested against the following platforms:
- Arduino.cc default ATmega based boards
- Arduino.cc SAMD Boards: https://github.com/arduino/ArduinoCore-samd
Our current and clear recommendation is, to use a SAM21G18 based board, as the chip provides 32k RAM and 256k Memory and 48Mhz clock speed. So plenty of space and performance at lowest possible current consumption.
Boards we can recommend
Elecrow Crowduino M0 SD
Attention: this boards runs a "M0 bootloader" and not the "Zero Bootloader". So you have to change the bootloader first
