DGC-CLDC0.01 CodeLock Door Controller
| Codelock and Doorlock Controller | |
|---|---|
| Developer | SirSydom |
| Phase | Developement Completed |
| µC-Board | ItsyBitsy M0 Express |
| µC | SAMD21G18 |
| KNX | MicroBCU |
| Manufacturer/Device ID | 7337 / 20 |
| Repository | On GitHub |
Short Description
This device is a Codelock with KNX connection which can send KNX telegrams on inserting codes/commands.
It also has some direct outputs to control a automatic lock (Like Abus CFA1000 or similiar).
There is a Keypad for inserting the codes, a piezo speaker for signaling key press and correct/wrong codes, a interface to a Motorlock remote controll (with 3,3V supply).
It fits into a case 40x80x20 (Hammond 1551KTBU) and can be placed in a "Elektronik-Unterputzdose".
Software
kdevice.xml: https://github.com/SirSydom/konnekting_codelock/blob/master/software/DGC-CLDC0.01/DGC-CLDC0.01.kdevice.xml
I plan to update the FW as soon there is a Konnekting Device Library V1.0.0 released, supporting FOTB - Firmware Over The Bus
Hardware
There will no be a Layout or even PVB. The PCB is very simple, you can build it with a bread board (Lochrasterplatine). Have a look here for help.
User Doc
Dev Doc
See GitHub
Build It
You need:
- Adafruit ItsyBitsyM0 Arduino-Board
- µBCU
- Keypad with 4x3 Matrix (have a look at AliExpress)
- Piezo-Buzzer
- Hammond 1551KTBU
- some ribbon cable 10 wires 1,27
(not complete, tbd)
Links
KNXUF Thread Konnekting Codelock